Can you hook up a turntable to a mac

Additionally, you will need to use an audio recording program with a monitoring feature. Begin by having your turntable properly set up.
Table of contents



Additionally, you will need to use an audio recording program with a monitoring feature. The monitor feature allows the signal from the turntable to be routed through the speakers on your computer. This procedure assumes an audio recording program of your choosing has been properly installed and configured. You may adjust the computer volume as needed and listen to your records while doing other things on your computer. Each time you unplug the turntable from the USB port of your computer, you may have to reset one or more preferences.

This is the nature of the beast with computers. Feel free to bookmark this page to refer back to it at any point. If you have any further questions or issues, feel free to contact the Audio Solutions Department , who will be happy to assist you. It's worth what you paid for it. Your mileage may vary! See link examples; not recommendation: I know nothing about these especially the quality but it seems a better solution to just digitize the vinyl.

Can be done on the cheap and still preserves the pops and crackles. Those are made to digitize the vinyl, not just play them back. The technology is cheap and available and not the real problem.

The real problem is as AlphaDoug said: You have to take the time to shepherd the process. I've had the cables between my stereo and Mac to digitize vinyl for a while now I have tried this myself too. I have used the output of this to connect to my Mac, which is just a simple RCA-Jack lead from the pre-amp output. You will then need some kind of software to record the tracks, and then split and clean up as desired. I have used Amadeus Pro in the past, which does make an easy job of the task. It's easiest to record an entire album side in one shot, then split the tracks later.

Amadeus also has a good noise elimination filter, which uses a sample of the background noise to cancel out itself. You can also clean up any excessive clicks or pops, using its magic repair tool. I have seen the USB decks that are available, as well as a few decks that have the RIAA pre-amp built in, but they all seem to be at the very cheapest level of quality. Also, if you're only going to be saving directly to MP3, then why bother? You might as well simply buy digital copies from iTunes Store. If you can find a reasonable deck, from say eBay, and make sure it has a half decent cartridge installed, then you may be surprised at how good it could sound.

Also, using a decent cartridge can help reduce a lot of the noise too. You might be able to pick up something for not much more money than a cheap USB deck - have a look at the old Dual for a start, It might come with a usable cartridge, but the low end Ortofon's are not badly priced, or try a Pickering which is what I have.

When you record initially, you need to start off with a non-compressed format, much as you would with photos using Raw or TIFF , using AIFF, or the software's own proprietary format.

HomePod - HomePod and turntable setup? | MacRumors Forums

Once you've done all the editing an cleaning you need, then you can finally save it to a standard format, either leaving at AIFF, or I like using Apple Lossless. MP3 is the audio equivalent of JPG, so you will get lost detail due to compression. And finally, all this will take a lot of time, remember you can only record each album in real time, and it can take a lot of time to split and scan the tracks to clean them up, then convert them all to a final format.

I have actually now given up on recording my albums, and actually play them from time to time. They still sound great, and some do still sound better than CD, or iTunes. I have done something similar but used an Hollywood Dazzle device and used the outputs from headphone jack to the RCA plugs on the Dazzle.

All replies

Thanks to everyone who has offered their suggestions. I've had my turntable for several years and previously had only connected it to a PC through my receiver. I had not looked at it closely before posting here and afte reading the replies I finally did examine it; much to my surprise, I discovered that it does have a USB connecting cord that I can use rather than going through my now defunct receiver. But another problem has surfaced: With that completed, Audacity can compress audio into the MP3 format.

It might be a good idea to bump up the default MP3 bit rate if you're an audiophile or if you have room for higher quality music. To get a quality recording, you'll need to prevent clipping the sound waves. If this is the case, carefully turn up the volume or increase the sensitivity of the line-in. Clipping is much worse than low signal input, but do try to get a strong signal for the sake of your effort and audio. Once you're reasonably happy with the sound levels you're getting, it's time for the real thing. Stop the audio and close any and all test tracks, just like you would a window.


  1. Latest sample galleries;
  2. lovetoknow dating.
  3. Can I Listen to My USB Turntable Through My Mac Speakers?!

Audacity creates uncompressed audio files from its source material and these files can take up a large amount of real estate on your hard drive. It's essential to have an adequate amount of space on your primary disk or a second dedicated data drive before starting to record. As a rule of thumb, think of thirty seconds of audio as four uncompressed megabytes of data.

This equates to about a half a gigabyte per uncompressed album. This will create a. The selection tool in the upper left-hand of the tool bar; the zoom in the lower right. These files will not be of the same quality as a ripped CD, or a file from the iTunes Store. Most analog audio signals have minor imperfections, such as normalization issues and pops, clicks and scratches in the case of a vinyl LP.

Audacity can fix these issues, but it's more of an art than a science. Audacity has a variety of filters that can be used to fix these imperfections, but these are advanced techniques. We've spent enough time on the basics alone! There are other programs that can remove sonic "dirt. But who can resist the warmth of vinyl converted to a digital audio file?

Latest in-depth reviews

The place to learn about your Mac. Tips and tutorials for novices and experts. Most Macs have an audio input jack, like the one on our eMac: Not the most intuitive symbol for audio input. After you plug everything in, you're ready to rock and roll! Configure Your System Preferences Now that your Mac can hear the recording, we need to make it listen. From the Apple menu, select System Preferences, and then select Sound.

Macinstruct

If you have an iMac, eMac or Apple portable, set the input to Microphone and run your finger over your Mac's built-in mic. The mic looks like a little hole in your case. This will make the input level indicator go crazy. Note that the blue Input Level bar is at maximum. Finally, select Line In as the device for sound input. Close the System Preferences. Your Mac is now ready to listen to your record player!